Recent Jobs For Sterling Pool Service

August 21, 2017 | Allen, TX

The owner went to his house and diagnosed the computer to be out of date and irreparable. He had to have a new Hayward saltwater chlorination system with control box, salt cell, flow switch, and necessary supplies installed. Since then, everything is reading properly and he is enjoying the pool.

August 15, 2017 | Plano, TX

The owner went to her pool and repaired a leak that impacted a return valve. The pool stopped leaking as a result.

August 10, 2017 | Dallas, TX

Our lead technician went to investigate and found a few things wrong with the pump. He needed to install a new pool pump lid, a new pool pump lid O-ring and repair additional leaks on the pool pump. After this was done, his system ran at full prime with no ...

August 4, 2017 | Garland, TX

Jessica liked her tile but wanted it thoroughly cleaned of the white calcium stains. We used a high-pressure media to bring her tile back to life. We also replaced her pool light bulb/gasket and the spa light fixture completely. We replaced her deco-seal around the pool (the mastic between ...

August 4, 2017 | Wylie, TX

The owner went to her house to get a bid prepared. He found her tile needed to be replaced, her coping stones around the pool were damaged, the dec-o-seal (mastic) was demolished, the deck was dented and pitted, and the pool/spa only needed to be acid washed. She approved ...

August 1, 2017 | Sachse, TX

Upon arrival, we replaced the pool pump capacitor. When we troubleshot the computer, we found there was a computer pump relay damaged by ants. We replaced this relay in her system and the pool pump is operational.

August 1, 2017 | Garland, TX

This is exactly what our technician found in the pool when he arrived. He replaced the capacitor and the pool is up and running.

July 28, 2017 | Plano, TX

Our technicians drained the pool then cut the plaster in places where there was exposed rebar. We sealed the rebar, patched the plaster, and started to refill the pool with water. The customer decided they would balance their own pool chemicals.

July 25, 2017 | Garland, TX

Upon arrival, our technician discovered that the pool light bulb and gasket needed to be replaced. The spa light fixture also had to be replaced. Once the repairs were made, everything worked properly.

July 19, 2017 | Sachse, TX

We removed and replaced the expansion joint, also known as deck-o-seal, between the coping and the deck.

July 18, 2017 | Garland, TX

We replaced the hose assembly on the discharge side of the pool sweep pump. The pool worked properly after that.

July 17, 2017 | Plano, TX

After we checked out her pool system, our technician noted that the DE was still at the bottom of your pool and on the pool steps. The filter had not been properly cleaned and re-charged with the proper amount of DE. We also found two bad filter grids and we ...

July 17, 2017 | Wylie, TX

Our technician checked all breakers and tested the time clock box and found the wires are hot. There have also been air in the system for about six weeks. He cleaned the filter grids and he bled out the pressure release valve on top of the filter but nothing helped. ...

July 13, 2017 | Sachse, TX

When we cleaned the filter, all of the grids were crushed due to the weight of the old DE. Great packs can weigh 100 pounds when this much time has gone by. The DE is usually slimy and smells like rotten eggs. We replaced all of the grids and added the ...

July 13, 2017 | Murphy, TX

Our crew checked out his sweep. We replaced the capacitor on the pool sweep pump motor and now it works as intended.