Providing exceptional service since 1987
Sterling Pool Service Small Logo
Call Us Today! 888-973-0274

Recent Jobs For Sterling Pool Service

July 17, 2019 | Dallas, TX

The owner went to his house to check out the new Polaris. Quickly he saw that Chris never cut the leader hose as the instructions direct to prevent these types of problems. Our technician took the proper measurements and cut the hose accordingly. Now the automatic pool cleaner moves around ...

July 15, 2019 | Murphy, TX

Because of salt system, stones must be sealed, which we did. This protects for one year against corrosion.

July 15, 2019 | Sachse, TX

We did a filter clean (no problem found) and evaluated the spa check valve for repairs but no other repairs were needed.

July 11, 2019 | Dallas, TX

After cleaning up the pool for the first time, the customer began a weekly cleaning service the next week

July 9, 2019 | Garland, TX

We reset his pool light and put in an RX Ball to treat the algae and black spots.

July 4, 2019 | Dallas, TX

We installed a new sweep motor.

July 3, 2019 | Sachse, TX

She approved our competitive bid for the removal and replacement of the expansion joint (mastic) and sealing the flagstone around the pool. She was able to sell her house less than two weeks later. Note: removing and replacing the deck-O-seal is typically done during a pool renovation, not by itself.

July 2, 2019 | Garland, TX

Sterling's owner went to his house to help as he had recently finished resurfacing his own deck. When he looked at George's pool deck it was confirmed that this needs some serious TLC. We were approved to resurface the deck, as well as leveling, expanding and dec-O-seal (mastic) that goes ...

July 2, 2019 | Sachse, TX

Our lead technician went to his house. He looked at the filter first, it's a 36" DE filter. A filter clean service is needed to evaluate the grids for replacement since up to three are crunchy already. We found 5 grids to be 'crunchy', replaced them and put the filter back together. ...

June 28, 2019 | Garland, TX

Our owner went to inspect her pool pump and found the capacitor had gone bad and needed to be replaced. After this was done, the pump ran well.

June 27, 2019 | Wylie, TX

We cleaned the pool and adjusted the chemicals. After we were done, she became a weekly service customer with us.

June 26, 2019 | Plano, TX

Our technician went to her house. He found the pool pump and motor to be in good condition with no repairs needed. However, he did see the filter pressure to be at almost 40psi. This high of a pressure indicates a filter clean is needed. He also saw the pool ...

June 25, 2019 | Garland, TX

Removed and replaced expansion joint between these areas. Note: Usually deck-O-seal work is done during a pool renovation and not by itself.

June 21, 2019 | Sachse, TX

The owner, Kevin, went to his house the same day. He evaluated the motor and found the really loud noise is due to bad bearings. He replaced the bearings inside the motor and that stopped the sound.

June 15, 2019 | Dallas, TX

The cartridges that were in the filter had become worn past the point of cleaning, causing the water to look brown. They needed to be replaced. She approved our bid to replace the cartridges. After she let the pump run throughout the weekend with new cartridges in place, her pool ...

Total: 409